| » Forum Index » Problems and solutions » Topic: Wacom |
|
Posted on 07/02/15 1:54:16 PM |
|
matt
** Posts: 84 Reply |
Wacom
Have an annoying problem with the Intuous Pro: the clone stamp will only work at a very low flow rate, despite both opacity and flow being set to 100% and pressure sensitivity being off. The healing tool eraser tool etc all work fine. Maybe use a 4lb hammer and chisel? Might cause warranty issues, I am led to believe.....  |
Posted on 08/02/15 6:21:39 PM |
|
Steve Caplin
Administrator Posts: 6994 Reply  |
Re: Wacom
Is the tablet working OK for painting? If so, it's unlikely to be a Wacom issue. Can you post a screenshot showing the tool active, with the Options bar visible? |
Posted on 09/02/15 5:32:27 PM |
|
matt
** Posts: 84 Reply |
Re: Wacom
Seem to have gotten it to work: the airbrush has to be active. Is this correct? The way I worked it out was that I noticed that irrespective of the brush size, it would only scribble very thin lines, so went through all other possibilities, and airbrush 'on' did the trick. Had already made a screenshot, how would I post it here? |
Posted on 10/02/15 08:46:24 AM |
|
Steve Caplin
Administrator Posts: 6994 Reply |
Re: Wacom
Glad it's working again! You can post a screenshot usually by clicking the Attachment button, to the left of the message window. This works for attachments under 100K. If they're bigger than this, then you'll have to host them elsewhere on somewhere like Photobucket, and link to them here. You can always use Save For Web to reduce the file size to under 100K. |